Programming; Symbols For The Properties Description; P0220 - Local/Remote Selection Source; P0221 - Speed Reference Selection - Local Situation - WEG CFW100 User Manual

3 PROGRAMMING

Next, the CFW100 frequency inverter parameters related to the Modbus RTU communication will be presented.
3.1

SYMBOLS FOR THE PROPERTIES DESCRIPTION

RO Reading only parameter
CFG Parameter that can be changed only with a stopped motor.
P0105 – 1 ST /2 ND RAMP SELECTION
P0220 – LOCAL/REMOTE SELECTION SOURCE
P0221 – SPEED REFERENCE SELECTION – LOCAL SITUATION
P0222 – SPEED REFERENCE SELECTION – REMOTE SITUATION
P0223 – FORWARD/REVERSE SELECTION – LOCAL SITUATION
P0224 – RUN/STOP SELECTION – LOCAL SITUATION
P0225 – JOG SELECTION – LOCAL SITUATION
P0226 – FORWARD/REVERSE SELECTION – REMOTE SITUATION
P0227 – RUN/STOP SELECTION – REMOTE SITUATION
P0228 – JOG SELECTION – REMOTE SITUATION
These parameters are used in the configuration of the command source for the CFW100 frequency inverter local
and remote situations. In order that the device be controlled through the Modbus RTU interface, the options
'serial' available in these parameters, must be selected.
The detailed description of these parameters is found in the CFW100 programming manual.
P0308 – SERIAL ADDRESS
Range:
1 to 247
Properties: CFG
Description:
It allows programming the address used for the inverter serial communication. It is necessary that each device in
the network has an address different from all the others.
P0310 – SERIAL BAUD RATE
Range:
0 = 9600 bits/s
1 = 19200 bits/s
2 = 38400 bits/s
Properties: CFG
Description:
It allows programming the baud rate for the serial communication interface, in bits per second. This baud rate
must be the same for all the devices connected to the network.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Programming
Default: 1
Default: 0