Table of Contents
Advertisement
-------------------------------------------------------------------------------------GEN III OPERATIONS MANUAL
Press the right arrow button and then press the "ENTER" button to load the clone file. The set will load the clone file and then
9.
turn off.
10. Remove the flash drive and turn the set on. The set will now have the channel line up and settings as the first set.
NOTE: The set you are cloning from and the set you are cloning to must have the same version of Mstar software. To check
the software version numbers enter function code "1111" and press the "ENTER" button.
Function Codes
Setup features are accessed using function codes. You will need an IR remote control to enter function codes. To enter a function code
using an IR remote control, press the "FUNCTION" button. A key ICON will appear on the upper left side of the screen. Press the "0"
button. CODE: 00000 will appear on upper the right side or the screen. Enter the desired function code. The numbers will appear as
you enter them. The following codes are available.
CODE
9999
1111 "ENTER"
15719
15729
15739
To access the setup menu enter function code 9999. MENU UNLOCK will appear briefly at the top of the screen. Press the "SETUP"
button to access the TV setup menu. Press the "FUNCTION" to enter the advanced TV setup menu. When you are done making
changes press the "SETUP" button until the OSD menu window closes.
Note: To use code 15729 you must have a USB flash drive with a valid clone file on it plugged into the Mstar update port.
Channel Scan
You will need to run an auto scan for the set to find all of your analog and digital channels. If you used the Setup Wizard to scan
channel skip this section.
Enter the setup menu. (FUNCTION – 0 – 9999 – SETUP)
1.
2.
Use the left right arrow buttons to select the Channel menu.
3.
Press the down arrow button. Use the left/right arrow buttons to select your signal source.
Select AIR if your set is connected to an off air antenna.
Select CABLE if your set is connected to a cable distribution system. This is the most
common setting.
4.
Press the down arrow button to select Auto Scan then press the right arrow button.
5.
Use the up/down arrow buttons to select the type of scan to perform.
Scan all channels
Digital channel only
Analog channel only
NOTE: All digital sets can only show digital cable channels broadcast in Clear QAM. Please contact your cable company
for a list of Clear QAM channels available to you.
6.
Press the ESC button once the channel scan is complete to clear the OSD.
7.
Once the scan is completed continue with Pillow Speaker Setup.
Scans all RF channels for both analog and digital channels. Select this if you are not sure what
type of channels are available.
Scans all RF channels for digital channels only. Analog channels are skipped. Use this scan for
set connected to an off air antennal.
Scans all RF channels for analog channels only. Digital channels will be skipped. If you are sure
there are no viewable digital channels available you can select this scan to speed up the scanning
process.
HealthCare Information, LLC
FUNCTION
ACCESS TV SETUP MENU (factory mode)
DISPLAY SOFTWARE VERSION
RESET
RESET AND LOAD CLONE FILE
RESET TO CATV LINEUP 1-1
15
Advertisement
Table of Contents
