Table of Contents
Advertisement
FUNCTION MENU
To enter the Function menu enter function code 9999 (FUNCTION – 0 – 9999) then press the "FUNCTION" button.
Channel List
Shows a list of all active channels. Use the up/down arrow buttons to select a channel in the list. The
selected channel will show behind the OSD channel list window. Press the "ENTER" button to exit.
Selected channel will be shown.
Advance Menu
Go to the TV Setup Menu. See pages 17-25.
Load From USB
Loads TV setup from a USB flash drive. A clone file must be created using the SAVE To USB function. To
load a clone file:
1.
2.
3.
Save To USB
Creates a clone file of TV setup data and saves it to a USB flash drive. To create a clone file:
1.
2.
3.
Mstar FW Update
Power On Setup
Key Pad Select
Power On Source
Insert a USB flash drive in to the SW-update Port on the rear jack panel. This is the port between the
HDMI jack and digital audio output jack.
Press the right arrow button.
Press the "ENTER" button to load setup data. Press the "Function" button to exit without loading.
...WAIT... will appear while data is loading. When data is finished loading the set will turn off.
Insert a USB flash drive in to the SW-update Port on the rear jack panel. This is the port between the
HDMI jack and digital audio output jack.
Press the right arrow button.
Press the "ENTER" button to save setup data. Press the "Function" button to exit without loading. "
...WAIT..." will appear while data is being saved. When finished "===Finish===" will appear and
the OSD will turn off.
M-Star firmware update. Loads TV software update. This is NOT used to update the Android
operating system. To update TV firmware:
1.
Insert an USB flash drive with the software update file on it. File must be named merge00.bin where
XX is any 2 digit number.
Press the Right arrow button to start the update process. "Search FW for Update ......" will appear on
2.
the screen. Once the file is found "FW Update! Wait ......" will appear and the power LED will flash
at various speeds. When the update is finished the set will turn off.
NOTE: If no update file is found OSD menu will close. The flash drive should only contain the
merge00.bin file.
Power on settings.
Selects the type of keypad being used. Settings must match the installed keypad for all keypad buttons to
function correctly.
6 Key – 9 Key – 10 Key – 20 Key
6 Key
9 Key
10 Key
20 Key
Input source the TV will select when turned on. Selections are:
None
TV will turn on to the same source it was set for when turned off.
TV Input
Television. Set will turn on the Power On Channel. See below.
HDMI 1
Rear HDMI input.
HDMI 2
Optional Side HDMI input.
IPTV
Android Apps Menu
AV1
AV Input.
AV2
Side AV Input.
HealthCare Information, LLC
6 button keypad on left side of set.
9 button keypad on left side of set.
10 button keypad on left side of set.
20 button keypad on front of set.
24
Advertisement
Table of Contents
