Table of Contents
Advertisement
Restore Default
Resets the set to factory defaults. All setting and channel line up will be lost. You will be prompted
before this action is carried out. You can also reset the set by entering function code 15719
(FUNCTION – 0 – 15719) with an IR remote.
Input Label
Allows the names of the input sources to be changed. To change the name of an input source.
1.
2.
3.
4.
Note:
Bank Sel.
Selects which channel bank (tier) to use. There are 4 banks available.
IR Band
Selects which IR band to use. The HCI IR remote must match the IR band setting. Only IR BAND 1
and IR BAND 2 can be selected. To change the IR remote band press and hold the power button on
the IR remote for 10 seconds.
IR bands can also be selected by pressing the CH+ and CH- buttons at the same time. Using the CH+
and CH- buttons you can select Off, IR1, IR2, IR3 and IR4. IR3 and IR4 are for universal remotes.
HCI IR remotes will not work with IR3 and IR4 settings.
HCI Setup
Special hospital settings.
LED Mode
Selects when Power LED is ON or OFF. Selections are Normal, Reverse
LED Blink
When set to ON power LED will blink when a buttons is pressed on an IR Remote, front panel or
pillow speaker. If power LED is on it will blink off. If power LED is off it will blink on.
Serial Control
Sets the type of serial control via the RJ-12 jack(s) on the rear jack panel. The Dual Pillow Speaker
board option will have 2 RJ-12 jacks. Selections are:
AC Power On
Sets how set functions when AC power is applied. Selections are:
AC ON
AC Off
POWER LOCK ON
Use the up/down arrow buttons to select the input name you wish to change.
Press the right arrow button.
Press the right/left arrow buttons to select from a list of standard names or press the down arrow
button to enter a custom name.
To enter a custom name use the right/left arrow buttons to select the character to enter or change
then use the up/down arrow button to change. Press the "ENTER" button when done.
The "HDMI SIDE" side HDMI port is an option and not available on all sets.
Normal
On when TV is on. Off when TV is off.
Reverse
Off when TV is on. On when TV is off.
Serial Control OFF – DVD Control – LodgeNetControl – HCIControl
Serial Control Off
DVD Control
LodgeNetControl
HCI Control
AC ON – AC OFF – POWER LOCK ON
Set turns on when AC power is connected. Can be turned on and off with
the power button.
Normal operation
Set turns on when AC power is connected. Can not be turned off with
power button.
HealthCare Information, LLC
No commands are accepted through the serial port(s).
Used to control HCI DVD player.
Used for LodgeNet systems.
Serial control using standard HCI codes.
21
Advertisement
Table of Contents
