Advertisement
Available languages
Available languages
EnglisH
14
5
If you want to interrupt the cooking process, press the start/pause
button.
The start/pause button lights up continuously and the time on the
,
display stops counting down or up.
Note: If you did not set a cooking time, the display shows 00:00.
6
To resume the cooking process, press the start/pause button again.
The time on the display starts counting down or up again and the
,
start/pause button starts flashing again.
Note: If you did not set a cooking time, the display starts counting up from 0
again when you press the start/pause button.
Note: If you do not resume the cooking process within 10 minutes, the
appliance goes into standby mode. In this mode, the start/pause button flashes
every 10 seconds.
7
When the set time has elapsed, the appliance beeps and the start/
pause button lights up continuously. Press any button to stop the
beeping.
Melting, keep warm, simmering, boiling, and frying with stirrer
1
Place the stirrer on the cone in the pot.
Note: For easy assembly, always put the stirrer in the pot before you add the
ingredients.
2
Put the ingredients you want to prepare in the pot. If necessary, add
water (e.g. to cook potatoes).
Caution: Make sure the ingredients in the pot do not exceed the MAX
indication.
Note: Certain ingredients may cause discolouration. If you spill ingredients on
the outside of the appliance, wipe away the spills immediately.
Tip: For cooking times and temperatures, see the recipe book.
3
If desired, put the lid on the pot.
4
Follow the instructions in section 'Using the control panel'.
5
When the set time has elapsed, remove the ingredients from the pot
with a spatula or a scoop. Press any button to stop the beeping.
Note: You can blend the ingredients in the pot with a hand blender, but only if
you remove the stirrer from the pot first.
Note: If you want to remove the stirrer, never touch the hot ingredients and
only touch the top of the stirrer.
6
Switch off and unplug the appliance.
Caution: When you switch off and/or unplug the appliance, the red
'heating plate hot' indication light goes out. However, the heating plate
may still be hot. Always let the heating plate cool down completely
before you handle or clean the base.
Advertisement
