Table of Contents
Advertisement
Auto Scan mode is disabled as soon as you switch the input manually. However, it
remains active when changing the Output Mode or Output Resolution. Note that you
can lock the front panel buttons using RS-232 commands.
3.6 Locking
The Locking feature provides two modes to disable the front panel buttons partially
or fully. The locking modes can be accessed using RS-232 or PC-GUI.
3.7 Factory Default
Factory default applies default setting to the unit. Factory default can be done from
Front panel, RS-232 and PC-GUI. To do the Factory default from the front panel
hold the Output Resolution button for 7 seconds or hold until you see all the inputs
buttons blink once.
3.8 PC-GUI
The SSW-HD-4 can be controlled using a free PC GUI. The PC-GUI uses the RS-
232 port on the device. Windows® GUI is available on the product's webpage.
4.0 Installation
1.
Connect up to four HDMI Sources to the HDMI Input ports of SSW.
2.
Connect an HD display to the HDMI Output port of SSW.
3.
Optional: Connect an RS-232 Cable from the RS-232 port of SSW to the RS-232
connector of any RS-232 controller (PC).
4.
Optional: Connect compatible audio devices using RCA cable to the SPDIF port.
5.
Connect the included 12V DC Locking Power supply. Do not over tighten the
locking power connector.
6.
Connect the power supply to an available electrical outlet.
PC-GUI
© Copyright 2017 Hall Research, Inc.
SSW-HD-4
7
Advertisement
Table of Contents
