Emf Information - Weldtronic TTIG200PADP Operating Manual

EMF Information

Considerations About Welding And The Effects Of Low Frequency Electric And Magnetic Fields Welding
current, as it flows through welding cables, will cause electro-magnetic fields. There has been and still is
some concern about such fields, However, after examining more than 500 studies spanning 17 years of
research, a special blue ribbon committee of the National Research Council concluded that: "The body
of evidence, in the committees judgment, has not demonstrated that exposure to power-frequency
electric and magnetic fields is a human-health hazard." However studies are still going forth and evidence
continues to be examined. Until the final conclusions of the research are reached, you may wish to
minimize your exposure to electromagnetic fields when welding or cutting.
To reduce magnetic fields in the workplace, use the following procedures:
 Keep cables close together by twisting or taping them.
 Arrange cables to one side and away from the operator.
 Do not coil or drape cables around your body.
 Keep welding power source and cables as far away from operator as practical.
 Connect work clamp to work piece as close to the weld as possible.
Limitations of warranty declaration regarding machine use
▲ The welding machine(s) described in this manual are designed exclusively for electrical arc welding
with shielding gases Argon, CO
machine for other purposes is not allowed. Using this machine in opposition with instructions can
put the welder in danger. Damage can occur to the welding machine if not operated according to
this manual. Failures and accidents due to such actions are not covered by warranty, nor can the
producer be held responsible
TitanTig 200P ACDC Pro Operators Manual Issue. A 0516
or Ar + CO mixture(s) employing TIG technology. Using this
2 2