Tig Mode - Weldtronic TTIG200PADP Operating Manual

Gun switch control current (Option)

TIG mode


Connect the TIG torch leads as detailed above. Ensure that a suitable inert gas supply is
connected.

Switch the power switch on the back panel to "ON"

Select the TIG welding mode using the selector switch.

There is voltage output at both output terminals.

After the parameters are set appropriately, open the gas valve of the cylinder, the gas valve on the
torch and adjust the gas regulator to obtain the desired flow rate.

The arc will start when the tungsten electrode touches the work piece and is lifted off after
touching by between 2-4mm

The arc will cease when the electrode (torch) is moved away from the work area
TitanTig 200P ACDC Pro Operators Manual Issue. A 0516
Torch switch
(Example shown only. Actual Torch may vary from above)
Current adjusting button,