Weldtronic TTIG200PADP Operating Manual page 27

pedal control of 3 wires and the aero socket has 14 leads.

When TitanTig 200 PAC/DC welding machines are operated in HF ignition method, the ignition
spark can cause interferences in equipment near the welding machine. Be sure to take specially
safety precautions or shielding measures

Connect the TIG torch leads as detailed above. Ensure that a suitable inert gas supply is
connected.

Switch the power switch on the back panel to "ON"

Select the TIG welding mode using the selector switch.

There is voltage output at both output terminals.

After the parameters are set appropriately, open the gas valve of the cylinder, the gas valve on the
torch and adjust the gas regulator to obtain the desired flow rate.

The arc will start when the tungsten electrode touches the work piece and is lifted off after
touching by between 2-4mm

The arc will cease when the electrode (torch) is moved away from the work area
TIG guides
The recommended size of tungsten/nozzle to be used can be selected from the table below
Electrode Welding
Diameter(mm) Current(A)
1.0
1.6
Electrode type
Type
Thoriated 2%
Ceriated
Lanthanated 1.5%
Zirconated 1%
TitanTig 200P ACDC Pro Operators Manual Issue. A 0516
Gas Nozzle
Diameter (mm)
15-80 8.0
70-150 9.5
DC welding of steel, stainless steel and copper
DC welding of steel, stainless steel and copper
DC welding of steel, stainless steel and copper
AV Welding of Aluminium
Electrode
Diameter(mm)
2.4
3.2
Mode
Welding Gas Nozzle
Current(A) Diameter(mm)
150-250 9.5
250-400 11.0
Colour
Red
Grey
Gold
White