Installation - Weldtronic TTIG200PADP Operating Manual

2.0 Installation

Worker and working area protection
Fumes and gases produced by welding are dangerous for your health. Ventilation in workplace must be
adequate to remove all harmful fumes and gases but not too strong since it could remove the shielding
gas flowing over work piece. Arc welding rays are dangerous for your eyes. The welder must always use a
welding helmet with a minimum protective shade glass No. 10 for MIG Welding. All personal protective
including working clothes, leather apron, gloves, etc. must always be worn when welding or handling the
work piece.
Unpacking
Check the packaging for any signs of damage. Carefully remove the machine and retain the packaging until
the installation is complete.
Positioning of the machine
Place the machine on a firm, dry and level surface. Where possible, do not allow dust or other impurities
to enter the machines cooling air flow. Preferably site the machine above floor level; for example on a
suitable carriage unit.
Notes for positioning the machine

The surface inclination should not exceed 15 degrees.

Ensure the free circulation of the cooling air. There must be at least 20 cm of free space in front of
and behind the machine for cooling air to circulate.

Protect the machine against heavy rain and direct sunshine.
NOTE! The machine should not be operated in the rain as the protection class of the machine, IP21S,
allows for outside preserving and storage only.
NOTE! Never aim metallic grinding spray/sparks towards the equipment.
Input connection
Before connecting the machine you should ensure that the correct supply is available. Details of the
machine requirements can be found on the data plate of the machine or in the technical parameters
shown in the manual.
The equipment should be connected by a suitably qualified competent person. Always ensure the
equipment has a proper grounding.
Never connect the machine to the mains supply with the panels removed.
TitanTig 200P ACDC Pro Operators Manual Issue. A 0516