Weldtronic TTIG200PADP Operating Manual page 29

4. Tig parameter adjust
Peak Amps5-170/200
Up slope 0-10S
Initial Amps 5-170/200
Pre flow 0-2s
Pulse off
5. AC parameters: Balance -5~+5
6. MMA parameter select: Hot start
Pedal switch control (Option)
When plug the fourteen-lead aero-socket of
pedal switch in it. Welder will identify the
pedal switch, the welding current knob on
the front panel will can't use，and only 2T
can be selected.
When use the
max-welding current beside the pedal ,can
set the max-current you want.
The eighth and ninth of the fourteen-lead
aero-socket is gun switch; The first and
second of the fourteen-lead aero-socket is
short circuit; The third、fourth and fifth of
the fourteen-lead aero-socket is pedal
adjustable resistance.
TitanTig 200P ACDC Pro Operators Manual Issue. A 0516
Base Amps 5-270/200
Pulse on
/ AC Frequency 50~250Hz
adjustment knob of
Down slope 0-10S
Pulse frequency 0.5-200Hz
/MMA amps 5-270/200
End Amps 5-170/200A
Post flow 0-10S
Pulse duty 5-95%
/ Arc force
Welding current control
12 pin control connector
Max Current Control