Makita 9561CH Instruction Manual page 9

Refer to the below table for the relationship between the
number settings on the dial and the approximate
rotating speed.
Number
1
2
3
4
5
010478
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded and
heated up.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Electronic constant speed control
•
Possible to get fine finish, because the rotating
speed is kept constantly even under the loaded
condition.
Soft start feature
•
Soft start because of suppressed starting shock.
Overload protector
•
When the tool would be employed over the
admissible load, it will stop automatically to protect
the motor and wheel. When the load will come to
the admissible level again, the tool can be started
automatically.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (handle)
Fig.4
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard (For
depressed center wheel, multi disc / abrasive
cut-off wheel, diamond wheel)
For tool with locking screw type wheel guard
Fig.5
Fig.6
WARNING:
The wheel guard must be fitted on the tool so that
•
the closed side of the guard always points toward
the operator.
min -1 (R.P.M.)
2,800
4,000
6,500
9,000
12,000
9
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels. (In some
European countries, when using a diamond wheel,
the ordinary guard can be used. Follow the
regulations in your country.)
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
clockwise or counterclockwise. Be sure to tighten the
screw securely.
To remove wheel
procedure in reverse.
For tool with clamp lever type wheel guard
Fig.7
Fig.8
Pull the lever in the direction of the arrow after
loosening the screw. Mount the wheel guard with the
protrusion on the wheel guard band aligned with the
notch on the bearing box. Then rotate the wheel guard
around 180°. Fasten it with the screw after pulling lever
in the direction of the arrow for the working purpose.
The setting angle of the wheel guard can be adjusted
with the lever.
To remove wheel
procedure in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
Fig.9
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
Fig.10
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing abrasive disc
(optional accessory)
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
Fig.11
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clock
To remove the disc, follow the installation procedure in
reverse.
guard, follow the installation
guard, follow the installation