Table of Contents
Advertisement
NOTE: IF THIS SEAL IS BROKEN THE SCALE MUST BE RE-SEALED BY
THE RELEVANT AUTHORITIES USING EITHER THE LEAD WIRE SEAL
OR AN ACCEPTABLE SEAL BETWEEN THE COVER AND THE BASE.
12.3 CALIBRATION COUNTER
The scales are sealed to prevent unauthorised calibration. However it is
possible to calibrate the scales as the software includes a counter to keep
track of how many times the scale has been calibrated and this value is
recorded on the scale so that future inspections can see if the scale has had
the counters incremented.
See the WBZ Service manual for details.
13.0 USER PARAMETERS
The user has access to the following parameters to change the way the scale
will operate. Some of these parameters can not be set by the user if they
are disabled at the factory.
To access these parameters hold the specific keys as described in the
following sections for about 4 seconds during the normal operation. The
respective parameter will be shown with the current setting sounding a beep.
To change the setting-
• Press the [0] key to scroll through the available options.
• When the desired setting is displayed, press the [Tare] key to save
the setting. The scale will return to weighing.
© Adam Equipment Company 2009
An alternative method would be to use
tamper-evident labels over the screw on the
bottom cover and over the joint between the
top and the bottom cover as shown in the
adjacent figure.
Metrology labels and additional security
measures may be added to the scale as
required by the national legislation.
12
Advertisement
Table of Contents
