Mac Address-Table Static - Cisco Catalyst 2960 Command Reference Manual

mac address-table static

mac address-table static
Use the mac address-table static global configuration command to add static addresses to the MAC
address table. Use the no form of this command to remove static entries from the table.
Syntax Description
mac-addr
vlan vlan-id
interface interface-id
Defaults No static addresses are configured.
Command Modes Global configuration
Command History Release
12.2(25)FX
Examples
This example shows how to add the static address c2f3.220a.12f4 to the MAC address table. When a
packet is received in VLAN 4 with this MAC address as its destination, the packet is forwarded to the
specified interface:
Switch(config)# mac address-table static c2f3.220a.12f4 vlan 4 interface
gigabitethernet0/1
You can verify your setting by entering the show mac address-table privileged EXEC command.
Related Commands Command
show mac address-table static
Catalyst 2960 Switch Command Reference
2-144
mac address-table static mac-addr vlan vlan-id interface interface-id
no mac address-table static mac-addr vlan vlan-id [interface interface-id]
Modification
This command was introduced.
Destination MAC address (unicast or multicast) to add to the address
table. Packets with this destination address received in the specified
VLAN are forwarded to the specified interface.
Specify the VLAN for which the packet with the specified MAC address
is received. The range is 1 to 4094.
Interface to which the received packet is forwarded. Valid interfaces
include physical ports and port channels.
Description
Displays static MAC address table entries only.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
78-16882-01