Cisco Catalyst 2960 Command Reference Manual page 328

show interfaces
This is an example of output from the show interfaces accounting command.
Switch# show interfaces accounting
Vlan1
Interface Vlan2 is disabled
Vlan7
No traffic sent or received on this interface.
Vlan31
No traffic sent or received on this interface.
GigabitEthernet0/1
No traffic sent or received on this interface.
GigabitEthernet0/2
No traffic sent or received on this interface.
<output truncated>
This is an example of output from the show interfaces capabilities command for an interface.
Switch# show interfaces gigabitethernet0/2 capabilities
GigabitEthernet0/2
Model:
Type:
Speed:
Duplex:
Trunk encap. type:
Trunk mode:
Channel:
Broadcast suppression: percentage(0-100)
Flowcontrol:
Fast Start:
QoS scheduling:
CoS rewrite:
ToS rewrite:
UDLD:
Inline power:
SPAN:
PortSecure:
Dot1x:
Multiple Media Types:
Catalyst 2960 Switch Command Reference
2-300
2 packets input, 1040 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
4 packets output, 1040 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Protocol
IP
Spanning Tree
ARP
Protocol
Protocol
Protocol
Protocol
WS-C2960G-24TC-L
10/100/1000BaseTX
10,100,1000,auto
full,auto
802.1Q
on,off,desirable,nonegotiate
yes
rx-(off,on,desired),tx-(none)
yes
rx-(not configurable on per port basis),tx-(4q2t)
yes
yes
yes
no
source/destination
yes
yes
rj45, sfp, auto-select
Pkts In Chars In Pkts Out
1094395 131900022
283896 17033760
63738 3825680
Pkts In Chars In Pkts Out
Pkts In Chars In Pkts Out
Pkts In Chars In Pkts Out
Pkts In Chars In Pkts Out
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Chars Out
559555 84077157
42 2520
231 13860
Chars Out
Chars Out
Chars Out
Chars Out
78-16882-01