Preparing Steam; Frothing Milk; Setting Up The Auto-Cappuccino Xs 6000 - Krups ESPRESSERIA AUTOMATIC Manual

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up liquids. As you need a higher
temperature to produce steam than to make an espresso, the appliance runs an additional pre-heating phase for steam.
We recommend that you use pasteurised or UHT milk that has been recently opened. Untreated milk does not
give the best results. After the steam function has been used, the nozzle can be hot, and we recommend that
you wait for a few moments before handling it.
Check that the steam
nozzle is correctly
fitted.
To remove any remaining
milk from the steam
nozzle, place a
receptacle under the
nozzle and press the
key.
To interrupt the steam function, just press any key. Be careful as the nozzle may be hot.
If the nozzle is blocked, unblock it using the needle supplied.
The maximum duration for production of steam per cycle is limited to 2 minutes.
SETTING UP THE AUTO-CAPPUCCINO XS 6000 (SOLD SEPARATELY)
This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte.
XS 6000
Attach the various
parts together.
To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly. It is recommend that you
wash it immediately by carrying out a cycle with steam and the accessory pot filled with water in order to clean the
inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory.

PREPARING STEAM

Press the key .
The light will flash while the appliance heats up.
Once pre-heating has been completed, the
producing steam by again pressing the
Press the button again to stop the cycle
Be careful, because the cycle does not stop immediately.
Pour the milk into your
milk jug.
Immerse the nozzle in
the milk.
Let the steam escape for at
least 10 seconds and then
again press the key to
stop the process.
Select the cappuccino
or caffe latte position
on the special nozzle.
light will remain on continuously and you can start
key.

FROTHING MILK

Initiate the steam func-
tion as explained in the
paragraph above.
The steam nozzle can be removed for more intense cleaning. Wash it out
with water and a little washing up liquid and a small non-abrasive brush.
Rinse and dry it. Before putting it back, ensure that the air inlet holes are
not blocked by any milk residues. If necessary, unblock them using the
needle supplied. Do not wash the steam nozzle in the dishwasher.
Fill up the milk pot and
place a cup or a glass
underneath the auto-
cappuccino nozzle.
7
Once your milk is frothy
enough...
Press the button
to start and then to
stop the cycle
...again press the
key to stop the cycle.
Be careful, because the
cycle does not stop imme-
diately.
Place your cup
under the coffee out-
lets and start a cof-
fee / espresso cycle.