Test Run - Grizzly G0819 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following: 1)
the main motor powers up and runs correctly, 2)
the Emergency Stop button works correctly, 3) the
feed motor powers up and runs correctly, and 4)
the Emergency Stop Plate works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
-22-
To test run machine:
1. Clear all setup tools away from machine.
2.
Press Emergency Stop
panel (see Figure 27).
Sanding Belt
Start Button
Conveyor
Belt Start
Button
Power
Indicator
Light
Figure 27. Location of control panel controls.
3. Open air valve so machine is getting proper
air supply (refer to Page 20).
Note: It is normal to hear a small amount of
air releasing from machine when air supply is
connected and machine is not running.
4. Install sanding belt (refer to instructions on
Page 26).
5. Connect machine to power supply. Power indi-
cator light should illuminate (see Figure 27).
6. Twist Emergency Stop button clockwise until
it springs out (see Figure 28). This resets
switch so machine can start.
Figure 28. Resetting Emergency Stop button.
Model G0819 (Mfd. Since 09/16)
button on control
Emergency
Stop
Button