Receiving - YASKAWA Z1000 Technical Manual

3

Receiving

Perform the following tasks upon receipt of the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged upon receipt.
• Verify receipt of the correct model by checking the model number printed on the name plate of the option package.
• Contact your supplier if you have received the wrong model or the option does not function properly.
Option Components on page
u
Option Package Contents
Description
–
Quantity
<1> The ground wire, ground wire screw (1) and LED labels are not required for option card installation to bypass units.
u
Tools Required for Installation
A Phillips screwdriver (M3 metric or #1, #2 U.S. standard) is required to install the option and remove bypass front covers.
Screw sizes vary by drive capacity. Select a screwdriver appropriate for the bypass capacity.
Use a short-shaft, magnetic screwdriver when installing the option card into the narrow enclosure models Z1B1D002 to
Z1B1D074 and Z1B1B001 to Z1B1B077.
Note: Tools required to prepare the option cables for wiring are not listed in this manual.
YASKAWA SIEPYAICOM25 Rev: A0 Z1000 Bypass Option PROFINET SI-EP3 Technical Manual
10.
Option Ground Wire
<1>
1 1
Screws (M3) LED Label
NS
<1>
3
3 Receiving
Refer to PROFINET
Installation Manual
MANUAL
MS
<1>
1 1
9