Installation Procedure - YASKAWA Z1000 Technical Manual

5

Installation Procedure

This section explains how to properly mount and install the communication option card to the Z1000 Bypass.
u
Section Safety
Do not connect or disconnect wiring while the power is on.
Failure to comply will result in death or serious injury.
Disconnect all power to the bypass and wait at least the amount of time specified on the bypass front cover safety label. After
all indicators are off, measure the DC bus voltage to confirm safe level, and check for unsafe voltages before servicing. The
internal capacitor remains charged after the power supply is turned off.
Do not remove the front covers of the bypass while the power is on.
Failure to comply could result in death or serious injury.
The diagrams in this section may include options and bypass units without covers or safety shields to show details. Be sure
to reinstall covers or shields before operating any devices. The option should be used according to the instructions described
in this manual.
Do not allow unqualified personnel to use equipment.
Failure to comply could result in death or serious injury.
Maintenance, inspection, and replacement of parts must be performed only by authorized personnel familiar with installation,
adjustment, and maintenance of this product.
Do not touch circuit boards while the power is on.
Failure to comply could result in death or serious injury.
Do not use damaged wires, stress the wiring, or damage the wire insulation.
Failure to comply could result in death or serious injury.
Do not use damaged wires, place excessive stress on wiring, or damage the wire insulation.
Failure to comply could result in death or serious injury.
Tighten all terminal screws to the specified tightening torque.
Loose electrical connections could result in death or serious injury by fire due to overheating of electrical connections.
Observe proper electrostatic discharge procedures (ESD) when handling the bypass and circuit boards.
Failure to comply may result in ESD damage to the bypass circuitry.
Never shut the power off while the bypass is outputting voltage.
Failure to comply may cause the application to operate incorrectly or damage the bypass.
Do not operate damaged equipment.
Failure to comply may cause further damage to the equipment.
Do not connect or operate any equipment with visible damage or missing parts.
YASKAWA SIEPYAICOM25 Rev: A0 Z1000 Bypass Option PROFINET SI-EP3 Technical Manual
DANGER
Electrical Shock Hazard
WARNING
Electrical Shock Hazard
Fire Hazard
NOTICE
5 Installation Procedure
11