Installation - Sanyo MIR-554 Instruction Manual

INSTALLATION SITE
CAUTION
Do not install it on the place (near the drain facilities etc.) where the corrosion cause material like the
sulfur compound etc. might be generated. The refrigeration unit is deteriorated, and it causes the
breakdown of the product due to the corrosion of the copper pipe.
■ A location where noting falls on
Do not install the product where things might fall on it. The product might be damaged, and it causes a
breakdown.

INSTALLATION

Door fixture
1. Remove the door fixture
Loosen 4 screws and remove the door fixture at the top
left of the cabinet.
2. Remove the packaging materials and tapes
Remove all transportation packaging materials and
tapes. Open the doors and ventilate the unit. If the
outside panels are dirty, clean them with a diluted
neutral dishwashing detergent. (Undiluted detergent
can damage the plastic components. For the dilution,
refer to the instruction of the detergent.) After the
cleaning with the diluted detergent, always wipe it off
with a wet cloth. Then wipe off the panels with a dry
cloth.
Leveling foot
3. Adjust the leveling foot
Extend the leveling feet by rotating them counterclockwise to contact them to the floor. Ensure the unit
is level.
4. Ground (earth)
WARNING
Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet is
not grounded, it is necessary to install a ground by qualified engineers.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
grounding may cause electric shock in the case of an incomplete circuit.
Note:
The chamber temperature may deviate from the set temperature when the unit is running with the heater
or motor energized.
14