Table of Contents
Advertisement
1.8 Using User-supplied Equipment
1.8.4
If Local Carrier-based Voice Mail Service is Used
It is possible to use voice mail service provided by your telephone company. After subscription, the
telephone company's voice mail system can answer calls automatically when you are busy or calls are not
answered, and callers can leave their messages in your mailbox of the voice mail system located at the
telephone company. You will receive an indication to notify you that a message is waiting. The Message/
Ringer Lamp will light red and a Single-CO (S-CO) button will flash red at moderate speed after the mailbox
has received messages, on a proprietary telephone (PT).
To listen to messages
PT
When the Message/Ringer Lamp is lit and an S-CO button flashes red moderately
Off-hook.
•
If your telephone company sends a special signal (Stutter dial tone) when you seize the
outside (CO) line, this is an indication that a new message was recorded. Approximately
5 seconds after the user hangs up one of the preprogrammed outside (CO) lines, or 3
minutes 46 seconds after the phone stops ringing, the PBX automatically seizes the line
and checks if a message has been recorded. If a new message was recorded in the
mailbox of the telephone company, the Message/Ringer Lamp lights red and the
corresponding S-CO button flashes red moderately.
•
If your voice mail service uses a stutter dial tone and the recorded message is over 3
minutes long, in some cases the Message/Ringer Lamp may not light and the
corresponding S-CO button may not flash.
•
A contract with your telephone company may be required for local carrier-based voice mail
service. For more details, consult your telephone company.
Customizing Your Phone
•
3.1.3 Customizing the Buttons
Create or edit a Single-CO (S-CO) button or Message button.
102
User Manual
(S-CO)
Press S-CO.
Press MESSAGE.
Advertisement
Table of Contents
