Start-Up And Control With I/O 19; How To Start Up The Drive - ABB ACS310 User Manual

5. Start-up

How to start up the drive

WARNING! The start-up may only be carried out by a qualified electrician.
The safety instructions given in chapter
during the start-up procedure.
The drive will start up automatically at power up if the external run command is on
and the drive is in the remote control mode.
Check that the starting of the motor does not cause any danger. De-couple the
driven machine if there is a risk of damage in case of incorrect direction of rotation.
Note: By default, parameter
and you cannot see all actual signals and parameters. To be able to view them, set
parameter 1611 PARAMETER VIEW to 3 (LONG VIEW).
• Check the installation. See the checklist in chapter Installation checklist in
ACS310 User's Manual (3AUA0000044201 [English]).
How you start up the drive depends on the control panel you have.
• If you have a Basic Control Panel, follow the instructions given in section
to perform a manual start-up
• If you have an Assistant Control Panel, you can either run the Start-up
Assistant (see section
manual start-up (see section
The Start-up Assistant, which is included in the Assistant Control Panel only,
guides you through all essential settings to be done. In the manual start-up, the
drive gives no guidance; you go through the very basic settings by following the
instructions given in section
and control with I/O
Safety
1611 PARAMETER VIEW is set to 2 (SHORT VIEW),
on page 20.
How to perform a guided start-up
How to perform a manual start-up
How to perform a manual

Start-up and control with I/O 19

on page 5 must be followed
on page 23) or perform a
on page 20).
start-up.
How