ABB ACS310 User Manual page 24

24 Start-up and control with I/O
Select the application macro according to which the
control cables are connected.
Continue with the application set-up. After
completing a set-up task, the Start-up Assistant
suggests the next one.
OK
• Press (when
continue with the suggested task.
• Press key
OK
to move to the following task without doing
the suggested task.
EXIT
• Press to stop the Start-up Assistant.
Check the direction of the motor rotation.
• If the drive is in remote control (REM shown on the
status line), switch to local control by pressing
• If you are not in the Output mode, press
repeatedly until you get there.
• Increase the frequency reference from zero to a
small value with key
• Press to start the motor.
• Check that the actual direction of the motor is the
same as indicated on the display (
forward and
• Press to stop the motor.
To change the direction of the motor rotation:
• If parameter 9914 PHASE INVERSION is not
visible, first set parameter
VIEW to 3 (LONG VIEW).
• Invert the phases by changing the value of
parameter 9914 to the opposite, ie from 0 (NO) to
1 (YES), or vice versa.
• Verify your work by applying input power and
repeating the check as described above.
• Set parameter 9914 back to 2 (SHORT VIEW).
is highlighted) to
Continue
to highlight
Skip
DIRECTION OF THE MOTOR ROTATION
.
reverse).
1611 PARAMETER
REM
9902 APPLIC MACRO
ABB STANDARD
[1]
EXIT
REM
Do you want to
continue with
EXT1 reference setup?
Continue
Skip
EXIT
and then press
LOC
.
LOC
REM
EXIT
DIR
means
forward
direction
REM
1611 PARAMETER VIEW
[3]
CANCEL
REM
9914 PHASE INVERSION
[1]
CANCEL
PAR EDIT
00:00 SAVE
CHOICE
00:00
OK
xx.xHz
xx x Hz .
x x A .
xx x % .
00:00 MENU
reverse
direction
PAR EDIT
LONG VIEW
00:00 SAVE
PAR EDIT
YES
00:00 SAVE