Troubleshooting; Setting Option Setup Method - Samsung AM007FN1DCH/AA Service Manual

4-3 Troubleshooting

4-3-1 Setting Option Setup Method

4-3-1-1 PCB option code input method
■ Slim 1way, 4way Series
Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the
same time.You need to set twice when setting indoor unit address and installation option.
■ The procedure of setting option
Entering mode for option setting.
Step 1
1. Remove batteries from the remote controller.
2. Insert the batteries while you press [+ Temperature] and [- Temperature] button at the same time.
3. Check if you have entered the option setting status.
Option setting procedure. (The option setting procedure is the same for other models.)
Step 2
After entering the option setting status, select the option as listed below.
• Option setting is available from SEG1 to SEG 24.
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
• Set the SEG2~SEG6, SEG8~SEG12 in the ON status and SEG14~18, SEG20~24 in the OFF status.
SEG1 SEG2 SEG3
0 X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X
Samsung Electronics
Entering mode for
setting option
High Temp Button
Low Temp Button
SEG4 SEG5 SEG6 SEG7 SEG8
X X X 1
X X X 3
SEG9 SEG10 SEG11 SEG12
X X X X X
X X X X X
Option setting mode
Mode change
High Fan Button
Low Fan Button
On(SEG1~12) Off(SEG13~24)
4-7