Volkswagen Golf 2013 Quick Reference Specification Book page 159

Fastener Tightening Specifications (cont'd)
Component
Tie rod-to-subframe nut
Tie rod-to-wheel bearing housing
- Nut (FWD)
- Bolt (AWD)
Trailing arm mounting bracket-to-body bolt
1)
Trailing arm-to-mounting bracket bolt
Trailing arm-to-wheel bearing housing bolt
1) 3)
Upper transverse link-to-subframe nut
Upper transverse link-to-wheel bearing housing
- Nut (FWD)
- Bolt (AWD)
Wheel hub-to-wheel bearing housing bolt
- FWD
- AWD
Replace fastener(s).
1)
Tighten bolts in curb weight position.
2)
For bolt tightening clarification, refer to ElsaWeb, Trailing Arm with Mounting
3)
Bracket.
Pre-tighten to 10 Nm in a diagonal sequence, and then tighten to tightening
4)
specification in a diagonal sequence.
VW Golf & GTI Quick Reference Specification Book • September 2012
1) 2)
1) 2)
1)
1) 2)
Fastener
size
- 90 plus an
additional 90°
(¼ turn)
- 130 plus an
additional 90°
(¼ turn)
- 130 plus an
additional 90°
(¼ turn)
- 50 plus an
additional 90°
(¼ turn)
- 90 plus an
additional 90°
(¼ turn)
- 90 plus an
additional 90°
(¼ turn)
-
1) 2)
- 130 plus an
additional 90°
(¼ turn)
- 130 plus an
additional 90°
(¼ turn)
1)
- 180 plus an
additional 90°
(¼ turn)
- 70 plus an
additional 90°
(¼ turn)
Nm
95
147