Preparation; Entering The Mmsi Code - Icom GM600 Basic Manual

■ Entering the MMSI code

First, you must enter the 9 digit MMSI
(Maritime Mobile Service Identity: DSC
self ID) code at power ON.
You can perform this initial code
entry ONLY ONCE. After entry,
only your dealer or distributor
can change it. If you have already
entered your MMSI code, these
procedures are not necessary.
q Hold down [ ] for 1 second to turn
ON the transceiver.
• Three short beeps sound.
• "Push [ENT] to Register Your MMSI" is
displayed.
w Push [ENT].
• Push [CLR] to cancel the entry. In that
case, the transceiver displays "Push
[ENT] to Register Your MMSI" again.
e Enter your 9 digit MMSI code.
r After entering the 9th digit, set the ID.
• The MMSI CONFIRMATION screen is
displayed.
Push
t Reenter your MMSI code to confirm.

PREPARATION

y After entering the 9th digit, register
the ID.
Push
+
Rotate
• When you successfully enter your MMSI
Push
code, the following screen is displayed.
• After that, the Main screen is displayed.
The registered MMSI code is displayed
Push
at the top of the screen.
+
Rotate
3
1
2
3
Push 4
5
6
7
8
9
10
11
12
13
14
15
16
6 6