ATTO Technology iPBridge 2600 Installation And Operation Manual page 40

EmailServerAddress
Configures the address of the server the unit must contact
in order to send out Email notifications.
set EmailServerAddress [IP address]
SaveConfiguration command required
get EmailServerAddress
EmailUsername
Configures the user name which authenticates the login
to the SMTP Email server. The user name must not be
more than 128 characters. A user name is not required if
the Email server does not require authentication.
set EmailUsername [username]
SaveConfiguration command required
get EmailUsername
EthernetSpeed
Regulates the speed of the iPBridge Ethernet port. If
Auto is enabled, the Ethernet speed is negotiated. When
hard set, 100 speed is half duplex.
Default: auto
set EthernetSpeed [dp1 | mp1 | all] [100 | 1000 | auto]
get EthernetSpeed [dp1 | mp1 | all]
EventLog
Regulates event logging. When enabled, the unit records
various system events to the event log.
Default: enabled
set EventLog [enabled | disabled]
get EventLog
EventLogFilter
Filters data from specific unit subsystems and levels when
EventLog is enabled. The specific entries supported are
platform-dependent. For set commands, the final
parameter indicates whether or not events from the
specified subsystem and level are displayed.
Default: all all all
set EventLogFilter [subsystem | all] [event level | all] [all |
none]
get EventLogFilter [subsystem | all] [level | all ]
Exit
Terminates the current CLI session over Telnet. This
command has no effect if used during a serial CLI
session.
Exit
ix
ATTO Technology Inc. iPBridge Installation and Operation Manual
ExpressFairness
Enables an iSCSI fairness algorithm. which, when a large
number of hosts are connected using iSCSI, prevents one
host from using all available bandwidth and starving
other connections.
Note
Enabling fairness when not needed may
adversely affect performance.
Default: disabled
set ExpressFairness [enabled | disabled]
get ExpressFairness
FirmwareRestart
Resets and reinitializes the iPBridge firmware. Use the
forced option to override any CLI reservations held by
other sessions.
FirmwareRestart <forced>
Help
Issued with no parameters displays a list of available CLI
commands. When a CLI command name is specified, a
command usage string and command description are
displayed.
Help <Command>
IdentifyBridge
Causes the Fault LED on the iPBridge to blink so that
you can identify the iPBridge hardware. Disabling this
option cancels the blinking.
Default: disabled
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Displays version numbers and other product information
for key components within the iPBridge.
Info
IPAddress
Controls the current IP address of the Ethernet ports on
the iPBridge. If IPDHCP
reports the current IP address assigned by the network
DHCP server, followed by the (DHCP) identifier.
Default: 10.0.0.0 if iPDHCP is disabled
set IPAddress [dp1 | mp1 | all] [xxx.xxx.xxx.xxx]
SaveConfiguration Restart command required
get IPAddress [dp1 | mp1 | all]
is enabled, the get command