ATTO Technology iPBridge 2600 Installation And Operation Manual page 46

Username
Specifies the user name for all sessions. It is case
insensitive, 1 to 32 characters, and cannot contain
spaces.
Default: root
set Username [username]
SaveConfiguration command required
get Username
VerboseMode
Controls the level of detail in CLI
command response output for the current CLI session.
Default: enabled
set VerboseMode [enabled | disabled]
get VerboseMode
VirtualDriveResponse
Provides proxy responses to SCSI INQUIRY and TEST
UNIT READY commands if a SCSI device selection times
out or has a busy event. Host systems can assign devices
consistently regardless of the device's state during the
execution of the commands.
Default: disabled
set VirtualDriveResponse [enabled | disabled]
get VirtualDriveResponse
Exhibit A-3 Default history Control table (buckets and interval in hexadecimal) for the RMON CLI
command.
Idx DataSrc
====================================================================
001 43.6.1.2.1.2.2.1.1.1 00000032 00000032 0000001e monitor 00000004
002 43.6.1.2.1.2.2.1.1.1 00000032 00000032 00000708 monitor 00000004
003 43.6.1.2.1.2.2.1.1.2 00000032 00000032 0000001e monitor 00000004
004 43.6.1.2.1.2.2.1.1.2 00000032 00000032 00000708 monitor 00000004
005 43.6.1.2.1.2.2.1.1.3 00000032 00000032 0000001e monitor 00000004
006 43.6.1.2.1.2.2.1.1.3 00000032 00000032 00000708 monitor 00000004
xv
ATTO Technology Inc. iPBridge Installation and Operation Manual
Help output and
BktReq BktGrant Interval Owner
VLAN
Sets Virtual LAN ID values for each Ethernet data port.
Up to 8 IDs can be stored per port. Incoming packets are
filtered if their tags are not on the list of VLAN IDs for
that data port. Outgoing packets are tagged to match
their connection. Each VLAN ID is assigned a VLAN
name of up to 64 characters. If no VLAN IDs exist for a
data port, VLAN is disabled for that data port.
set VLAN [dp1 | all] [[VLAN ID] [VLAN Name] <delete> |
[all] [delete]]
get VLAN [dp1 | all]
Voltage
Displays the current voltage levels monitored by the unit.
get Voltage [VDDA | VDDB | VDDC | VDDD | all]
WrapEventLog
Controls EventLog output wrapping. When enabled, the
unit logs up to 2048 event entries before overwriting the
first entries. When disabled, the unit stops logging event
entries at buffer full.
Default: enabled
set WrapEventLog [enabled | disabled]
SaveConfiguration command required
get WrapEventLog
WrapTraceLog
Controls Username output wrapping. When enabled,
the unit logs up to 2048 trace entries before overwriting
the first entries. When disabled, the unit stops logging
trace entries at buffer full.
Default: enabled
set WrapTraceLog [enabled | disabled]
get WrapTraceLog
Status