Connect The Printer To An Ethernet Network - Honeywell PM23c User Manual

Connect the Printer to an Ethernet Network

PM23c, PM43, and PM43c Mid-Range Printer User Manual
Use the Ethernet port to set up the PM43 or PM43c as a network printer.
The printer is set to automatically retrieve an IP number from the network
(DHCP) when you turn on the printer. You can use the network
connection with InterDriver. You can also use it to directly send
commands to the printer through a terminal connection (Telnet), or you
can send instructions through FTP.
1 Turn the printer off.
2 Connect the Ethernet cable to the Ethernet port in the rear of the
printer and connect the other end of the cable to your network.
3 Turn the printer on.
If your printer uses a DHCP server to assign IP addresses, the IP
address appears in the lower left corner of the screen.
• For an icon printer, use Intermec PrintSet to retrieve the printer IP
address.
If you are not using a DHCP server to automatically assign IP
addresses to devices in your network, you must set a static IP address
and other network information manually. Continue with the next step.
4 For a non-DHCP network:
• For a full touch printer, from the Main Menu select Settings >
Communications > Ethernet > IPv4 or IPv6 and change the
settings as needed.
• For an icon printer, configure the Ethernet settings through
PrintSet.
IPv4 and IPv6 Ethernet Settings
Setting
(IPv4) IP Assignment Method
(IPv4) IP Address
Subnet Mask
Default Router
DHCP Response
(IPv6) IP Assignment Method
(IPv6) IP Address
Chapter 3 – Connect the Printer
Default
DHCP
0.0.0.0
0.0.0.0
0.0.0.0
Broadcast
Automatic
Automatic
47