Introduction
This guide describes the Applicator Interface kit for PX940 Industrial Series
printers.
Description
The installation instructions describe how to physically install and configure
the applicator board in the printer.
Printer Firmware
The printer must be fitted with Honeywell Fingerprint v8.60 (or later).
Installation Kit
The Applicator Interface Board installation kit includes:
• One Applicator Interface Board
• One power cable
• One USB cable
• One spacer screw
• One 3X8mm Torx screw
• Two 4X8mm Torx screws
The only tools required for installation are the #T10 and #T20 Torx
screwdrivers.
PX940 Applicator Interface Installation Instructions
1