Assembly; Assembling The Handlebar And Throttle; Fitting Blades And Trimmer Heads - Husqvarna 543RS Operator's Manual

H1158111-38,543RS,GB.fm Page 12 Monday, January 11, 2016 1:47 PM
Assembling the handlebar and
throttle
• Fit the handlebar in the handlebar clamp on the shaft
using four screws.

Fitting blades and trimmer heads

WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
!
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.
12 – English

ASSEMBLY

Fitting the trimmer guard and trimmer
head
• Fit the correct trimmer guard (A) for use with the
trimmer head.
• Fit the guard as shown in the diagram. Tighten
securely.
• Position the trimmer guard beside the arrow mark.
• Fit the drive disc (B) and support flange (C) on the
output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin into the hole to lock the shaft.
• Turn the trimmer head counterclockwise when
installing.
• To dismantle, follow the instructions in the reverse
order.
D
C
B