Trigger In Setup
Allows you to set up the system so that it can be switched on via an external device in the system.
Trigger Out Setup
Allows you to set up the system so that the MP-50 can control other devices in the system.
Off – No action
Source – When the preset source for any zone is selected, it will trigger. Use source setup menu
to associate with a source.
Source A – When the preset source for Zone A/Main zone is selected, it will trigger.
Source B - When the preset source for Zone B is selected, it will trigger.
Power A – When Zone A/main zone is On, it will trigger
Power B - When Zone B zone is On, it will trigger
Power any - When any Zone is On, it will trigger
Network Configuration
Change the network mode to manual or automatic.
For more info, see the Network Setup chapter.
Streaming Setup
Configure streaming player control setup.
•
Streaming players can control volume – set to Off or On
•
Streaming players can change input source – set to Off or On
•
Streaming players can power on the device from standby mode – set to Off or On
NOTE:
The setup of the streaming player itself is done in the interface of the HOME section.
46