Hybrid Auro-3D And Dolby Atmos Example - Lyngdorf Audio MP-50 Owner's Manual

Hybrid Auro-3D and Dolby Atmos Example

SUB L
LW
Subwoofer
Left Wide
Left
HLS
Height Left
Surround
LS
Left
Surround
SUB LR
Subwoofer
Left Rear
In this hybrid system, there are LTF/RTF and LTR/RTR speakers for Dolby Atmos, while there are
only HL/HR speakers for Auro-3D. Playing back Dolby Atmos material in this system will use the
LTF/RTF and LTR/RTR speakers as usual, while not using the HL/HR speakers. When playing
back Auro-3D material in this setup, the system will map the HLS/HRS channels to the LTR/RTR
speakers, so the HL/HR speakers and the LTR/RTR speakers will be playing the HL/HR and
HLS/HRS channels respectively.
Dolby-enabled speakers
For Dolby Atmos setups, it is possible to add Dolby-enabled speakers instead of using top
speakers mounted in the ceiling.
If you have Dolby-enabled speakers on top of your front and surround speakers, go to the settings
for these speakers and activate the Dolby-enabled speaker option, and then select the
corresponding size. The system will then find out which signal is to be routed for this speaker and
will add an output for it.
HL HC
Height Left Height Center
L C
Left Center
SUB LFE
Subwoofer LFE
LTF
Left Top
Front
LTM
TOP
Left Top
Top
Middle
LTR
Left Top
Rear
LRS
CB
Left Right
Center Back
Surround
35
HR
Height Right
R RW
Right Right Wide
RTF
Right Top
Front
RTM
Right Top
Middle
HRS
Height Right
Surround
RTR
Right Top
Rear
RRS
Right Rear
Surround
SUB R
Subwoofer
Right
RS
Right
Surround
SUB RR
Subwoofer
Right Rear