Setup Options Of Main And Line Outputs - Lyngdorf Audio RoomPerfect RP-1 Owner's Manual

Room processor
Table of Contents

Advertisement

Setup options of Main and Line outputs

As described in "Routing" and "Crossover Frequency" there are many ways to utilize the Main and Line out-
puts. Here we have described the three most common set-up´s. Please note the products, outputs and cross-
over frequencies are chosen randomly in these descriptions. Combine them as you see fi t.
1.
Single-amp set-up with full range main speakers (no subwoofer).
A poweramp is connected to Main Outputs Left and Right. No crossover is selected.
2.
Poweramplifi er and subwoofer set-up.
A poweramp is connected to the Main Outputs Left and Right and the highpass crossover is set at 80Hz.
The Subwoofer is connected to the Line Output and the lowpass crossover is set at 80Hz. Remember to
bypass or set the subwoofer cut-off frequency to maximum.
Speakers
3.
Lyngdorf 2+2 setup.
A poweramp is connected to Line Outputs Left and Right and the highpass crossover is set at 400Hz.
Lyngdorf boundary woofers are connected to Main Outputs Left and Right, through a poweramp, and
the lowpass crossover set at 400Hz.
Speakers
14
Main Output Left
No filter
Speaker
Main Output Left + Right
Highpass filter set at 80Hz
Poweramp
Line Output Left + Right
Highpass filter set at 400Hz
Poweramp
RP-1
Main Output Right
No filter
Poweramp
RP-1
Line Output Right
Mono lowpass filter set at 80Hz
Active subwoofer
RP-1
Main Output Left + Right
Lowpass filter set at 400Hz
Poweramp
Speaker
Boundary woofers

Advertisement

Table of Contents
loading

Table of Contents