How To Pair Remote Control In Rf Mode; Setup Procedure - Lyngdorf Audio MP-50 Owner's Manual

How to Pair Remote Control in RF Mode

The MP-50 remote has both an IR and RF mode, and is by default set to IR.
To pair the RF remote control to the MP-50:
1. Turn on the MP-50.
2. Hold down Play/Pause and OK until the remote control´s green LED flashes.
3. Release the buttons.
4. Point the remote control at the MP-50 and hold it within 30cm / 1 foot of the front panel;
when the green LED stops blinking, the remote is connected.
5. The remote is now RF paired to the MP-50.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.
Switching Remote Between RF and IR Mode
To switch the remote from IR to RF mode, hold down OK and 2. The LED will flash green twice.
To switch the remote from RF to IR mode, hold down OK and 1. The LED will flash red twice.
If you press a button on the remote and the red LED at the top turns on, then
you are in IR mode. If it turns green you are in RF mode.
Set up the MP-50 surround sound processor by following these steps:
1. Connect the speaker to the power amplifiers.
2. Connect all external equipment, audio and video, home automation system, mains, etc.
to the MP-50.
3. Switch on the MP-50 and all connected equipment.
4. Access the setup menu via the web interface or the remote and OSD.
5. Go to "Speaker and Room" and set up the system.
6. Connect the amplifiers to the specified outputs.
7. Select and press "Verify speakers."
8. Run RoomPerfect™ Guided Setup.
9. Set up video sources, audio, zone b, etc.
10. Save and back up settings.

Setup Procedure

9