Changing The Grinding Wheel; Specifications - Metabo DS 125 W Original Operating Instructions

Grinding Wheel Wear
Grinding wheels will naturally wear down with use. This
requires a regular resetting of the tool rest and spark
arrester bracket to the gap size as shown in fi gure 5.
When a certain minimum wheel diameter is reached the
tool rest can not be set any closer and the wheel has to
be replaced. Depending on the grinding wheel diameter
the following minimum wheel diameters (d
125 Ø 150 Ø
d 75 mm 110 mm
min

Changing the Grinding Wheel

If the wheel needs replacement because it is worn down
or you want to use a different type of grinding wheel, the
mounted wheel is to be removed as shown in fi gure 7.
Please make sure that the hexagon nut (item 4) on the
left side of the machine has a left-handed thread, i.e.
must be turned in a clockwise direction to undo.
Changing the Grinding Wheel
If the wheel needs replacement because it is worn down
or you want to use a different type of grinding wheel, the
mounted wheel is to be removed as shown in fi gure 7.
Please make sure that the hexagon nut (item 4) on the
left side of the machine has a left-handed thread, i.e.
must be turned in a clockwise direction to undo.
Specifi cations
Stock-no.
Power supply
Motor power P
1
No-load speed
Grinding wheel Ø
Grinding wheel width
Machine noise information: workplace sound pressure Lp level below 80 dB(A).
) apply:
min
175 Ø 200 Ø
130 mm 135 mm
DS 125 W DS 150 W
030 001 2540 030 001 5034 030 001 7533 030 001 7541 030 002 0003 030 002 0011
1 ~ 230 V 1 ~ 230 V
200 W 330 W
-1 -1
2750 min 2750 min
125 mm 150 mm
20 mm 20 mm
Never confuse the two hexagon nuts (item 4): This could
damage the thread on the rotary shaft (item 7).
2
4
7 3
1 Hexagon head cap screw
2 Hexagon nut (if necessary with serrated lock washer)
3 outer wheel cover
4 Hexagon nut (on the left side of the machine with
left-handed thread!)
5 counter fl ange
6 grinding wheel
7 Rotary shaft
Damaged parts, particularly safety devices, must
only be replaced with genuine parts. Parts which
have not been tested and released by the manufacturer
can lead to unforeseen damage.
Cleaning
Caution! Always pull out the plug prior to
cleaning!
Occasionally clean the outside of the double grinding
machine using a damp cloth.
Make sure to clean the inside of the grinding wheel
casing. The grinding wheels must always be able to run
smoothly within the casing.
DS 175 W DS 175 D
1 ~ 230 V 3 ~ 400 V
450 W 570 W
-1
2750 min 2600 min
175 mm 175 mm
25 mm 25 mm
10
1
7
5 6
DS 200 W DS 200 D
1 ~ 230 V 3 ~ 400 V
580 W 740 W
-1 -1
2650 min 2600 min
200 mm 200 mm
25 mm 25 mm
-1