Adjusting Color Uniformity - Epson BrightLink 697Ui User Manual

Wireless full hd 3lcd ultra short-throw interactive display

Hide thumbs Also See for BrightLink 697Ui:

Table of Contents

3. Aim the remote control at that projector.

4. Hold down the ID button on the remote control while you press the numeric button that matches the

projector's ID. Then release the buttons.

5. Press the ID button on the remote control to check if the ID-setting process worked.

You see a message displayed by the projector.

• If the remote control is listed as On, the remote control ID is set to operate only the listed projector.

• If the remote control is listed as Off, the remote control ID is not set properly. Repeat the steps

above to set the ID to match the projector you want to control.

Parent topic:

Adjusting Color Uniformity

If the color tone is uneven on each screen, adjust the color tone balance in the Extended menu of each

projector. (The color tone may not be uniform even after performing color uniformity.) Color Uniformity is

disabled in the built-in whiteboard mode.

Note: If you cannot adjust color uniformity, make sure the Color Mode setting is not set to Dynamic.

Projector Identification System for Multiple Projector Control