Temporarily Changing The Top Of Form; Resetting Top Of Form To The Factory Default; Forms Tear-Off Feature - Oki ML5520 User Manual

4. If the printer is ON line, press SEL|MENU (1) to take the printer Offline.
The SEL light goes out.
5. Press and Hold SHIFT, then:
> Press LF|Micro Feed Down (3) to set the TOF higher (the paper moves down).
> Press FF/LOAD|Micro Feed Up (4) to set the TOF lower (the paper moves up).
(When you begin pressing the Micro Feed key, the printhead will move to the right).
6. Press SEL|MENU (1) to save the setting and place the printer back on line.
To reset the Top of Form to the factory default, see
default" on page 33.
T
EMPORARILY CHANGING THE TOP OF FORM
If you turn the platen knob when the printer is not at Top of Form,
the TOF will misalign. Always feed the paper to TOF before turning
the platen knob.
To move the Top of Form position lower for one page only:
1. Press SEL to deselect the printer.
2. Press LF to lower the position of the Top of Form.
R
ESETTING TOP OF FORM TO THE FACTORY DEFAULT
The factory default setting for the Top of Form (where the printing should begin) is 1" down
from the top of the page.
To reset the Top of Form to the factory default:
1. Remove paper from the paper path.
2. Turn the printer off.
3. Press and hold PARK + QUIET|TOF while turning on the printer.
4. Reload paper.
F -
ORMS TEAR OFF FEATURE
This feature is normally turned off. To use Forms Tear-Off, you must enter the menu and
change the setting to the desired time interval (see
on page 34).
The Forms Tear-Off feature allows a printed continuous forms page to be torn off without
wasting paper or adjusting the printer. It can be used for rear feed continuous forms,
bottom feed continuous forms (with the optional push tractor installed), or for top feed roll
paper (with optional roll paper stand installed).
When the printer is turned on, the paper feeds to the tear-off position.
When data is received, the paper automatically moves down to the print position (TOF) and
printing begins.
NOTE
You can also move the paper down to the print position manually by pressing
TEAR.
"Resetting top of form to the factory
CAUTION!
"Changing the forms tear-off setting"
Using your printer > 33