Oki ML5520 User Manual page 24

9. Adjust the left tractor until the holes in the paper are centered on the pins then lock
the lever and close the left tractor cover.
NOTE
If the paper is too loose, or too tight, it can cause jams.
10. Lower the sheet guide and slide it towards the front of the printer until the marks
align.
11. Place the wire guide in the sheet guide on the pull-up roller assembly.
12. Press FF/LOAD.
NOTE
The factory default setting for the Top of Form (where the printing should
begin) is 1" down from the top of the page. To change the setting, see "Top
of Form (TOF)" in the previous chapter.
Using your printer > 24