Porsche 92854 Owner's Manual page 98

Headlight adjustment
Headlight adjustment should be done with a
headlight aiming device under the following
conditions:
At curb weight of car (i.e. car ready for use
and with full fuel tank).
Driver's seat should be occupied by a person
or a weight of approx. 1 5 5 lbs (70 kg).
Tire pressure must be correct.
Roll car forward a few feet so that the sus-
pension settles into normal position.
1. Remove cover of rubber buffer.
2. Remove Phillips screws from rubber buffer
and the transparent side cover with a
screwdriver.
Adjustment screws
Each headlight and each additional headlight
has two adjusting screws. One for lateral and
one for vertical setting. Each fog light has one
adjusting screw for vertical adjustment. By
turning these screws left or right, the corres-
ponding beam position is effected. Each fog
light has one adjusting screw for vertical ad-
justment.
Screw "a" (lateral adjustment)
right turn = beam moves right
Screw "b" (vertical adjustment for headlight
and fog light)
right turn = beam moves up
left turn = beam moves down
Screw "b" (vertical adjustment for additional
headlight only)
right turn = beam moves down
left turn = beam moves up
95