Contents Of Package - Rikon Power Tools 10-324 Installation & User Manual

A
B
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH MUST BE IN
REMOVE THE BANDSAW BLADE
1. Remove the bandsaw blade that is mounted on your machine. NOTE: Refer to your bandsaw's original
Operator's Manual for instructions on the proper steps to safely perform this operation on your particular
machine model.
INSTALLING THE UPPER BLADE GUIDES
Remove the original, upper blade guard that
surrounds the blade above the table.
1. Lower the upper blade guides until they touch
the table. This will give the best access to the blade
guard, and make it easier to remove it from the saw
frame.
2. Remove the blade guard from the guide post by
unscrewing the two Hex Socket Cap Screws that hold
it in place. Figure 1. Save these screws as they will
be needed to install the new guard that is included
with the Retrofit Kit.

CONTENTS OF PACKAGE

C
ASSEMBLY
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
CONTINUED ON PAGE 4
TABLE OF LOOSE PARTS
Tools and Tool Holder:
A. Upper Blade Guide Assembly
B. Lower Blade Guide Assembly
C. Upper Blade Guard
D. Scale for Blade Guard
D
Additional Tools Required - not supplied
#2 Phillips Screwdriver
10mm Wrench or an Adjustable Wrench
NOTE: Parts referenced throughout the
instructions refer to the key numbers of
the Parts Diagrams and Parts Lists on
REMOVE
GUARD'S
2 SCREWS
ON POST
3
pages 10 and 11.
FIGURE 1