Basic Measurement Techniques; Lest Connections - Keithley 590 CV Instruction Manual

GETTING STARTED
Table 2-3. Power Up Default Conditions
Mode
Range
Flequency"
Model
Filter
Rate
zero
Trigger Mode
Trigger Source
Bias Source
Bias Waveform
Start Time
Stop Time
Step Tie
First Bias
Last Bias
Bias Step
Default Bias
Count (#readings DC or
external)
Plotter Grid Type**
Plotter Pen Type**
plotter Line Type**
Plotter Label Type**
Plot Type**
Buffer to Plot**
XY s=*g**
IEEE Primary Address**
Cable #**
"59011OOk or 590/1OOk/lM units
NOTE: This configuration can be altered with SAVE 1 ex-
cept **. To restore tbis configuration, use RECALL 0.
Condition
2nF
1oOkHZ
Parallel
On
10 readingslsec
Off
Sweep
Front Panel (MANUAL)
lmsec
ov
t;
ov
450
0 (Full Grid)
1 (Fen #l)
7
(Solid Line)
0 (ml Labels)
0 (C vs v)
0 (Buffer A)
Off
15
7
(to front panel)
2.4.6 Warm Up Period
The Model 590 can be used immediately when it is first
turned on. Note, however, that the unit must be allowed
to warm up for at least one hour to achieve rated accumcy.
Note, however, that you must use the CAL key to obtam
rated accomcy if the ambient temperature changes by more
than 2%
2.5 BASIC MEASUREMENT TECHNIQUES
The following paragraphs wilI take you through simple
step-by-step procedures to take one-point measurements,
obtain simple CV lots, and
measurements. TK s
erform fundamental C vs t
ese proce ores are intended only to
serve as a starting point, and they may not serve your
specific needs. Refer to Section 3 for detailed information
on making these type of measurements.
2.5.1 Test Connections
Use the basic test connections shown in Figure 2-3 for the
examples in tbis section. Paragraph 3.2 covers connecting
methods in more detail.
2-l 7