Checking The Configuration - Huawei AR3200 Series Configuration Manual - Lan

Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bridge bridge-id
The bridge group view is displayed.
Step 3 Run:
bridging { ip | others } disable
The bridge group is disabled from bridging specified protocol packets.
To allow a bridge group to forward specified protocol packets, enable the function that bridges
the protocol packets on the bridge group. By default, a bridge group bridges all protocol packets.
----End

2.6.8 Checking the Configuration

After configuring remote bridging integrated with IP routing, you can view the traffic statistics
on a bridge group or a specified interface in the bridge group.
Prerequisites
The configurations for remote bridging integrated with IP routing are complete.
Procedure
l
l
l
----End
Example
Run the display interface bridge-if [ bridge-id ] command to view information about the
Bridge-if interface.
<Huawei> display interface bridge-if 1
Bridge-if1 current state : UP
Line protocol current state : UP
Last line protocol up time : 2010-10-09 18:50:53 UTC-08:00
Description:HUAWEI, AR Series, Bridge-if1 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 1.1.1.3/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-0e0b-0100
Physical is BRIDGE-IF
Current system time: 2010-10-11 08:52:21-08:00
Issue 02 (2012-03-30)
Run the display interface bridge-if [ bridge-id ] command to check information about the
Bridge-if interface.
Run the display bridge [ bridge-id ] information command to check information about
the remote bridge group.
Run the display bridge traffic [ bridge bridge-id | interface interface-type interface-
number ] command to view the traffic statistics on the bridge group.
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Transparent Bridging Configuration
59