Optional) Configuring Vlan Damping - Huawei AR3200 Series Configuration Manual - Lan

Huawei AR3200 Series Enterprise Routers
Configuration Guide - LAN
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
mtu mtu
The MTU of the VLANIF interface is set.
The MTU of a VLANIF interface ranges from 46 to 1500, in bytes. The default value is 1500.
----End

3.5.5 (Optional) Configuring VLAN Damping

Context
Perform the following steps on the AR3200 to configure VLAN damping.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
The VLANIF interface view is displayed.
The VLAN associated with the VLANIF interface is created.
Step 3 Run:
damping time delay-time
The delay for VLAN damping is set.
The value ranges from 0 to 20, in seconds.
Issue 02 (2012-03-30)
run the shutdown command and then the undo shutdown command, or run the restart
command in the interface view.
If you change the MTU of an interface, you must use the mtu command to change the MTU
of the peer interface to the same value; otherwise, services may be interrupted.
NOTE
If the MTU is too small whereas the packet size is large, the packet will probably split into many fragments.
As a result, the packet may be discarded due to insufficient QoS queue length. To avoid this situation,
lengthen the QoS queue accordingly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 VLAN Configuration
91