ADJ Vizi BSW 300 User Instructions page 13

Vizi BSW 300
System Menu: When making adjustments press ENTER to
confirm your setup then press and hold the MENU button
for at least 3 seconds. To exit without making any adjust-
ments press the MENU button. The display will lock after 30
seconds, press the MENU button for 3 seconds to unlock.
DMX SETTINGS -
DMX Address - With this function, you can adjust the desired DMX-
address via the Control Board.
1. Access the main menu, and press the UP or DOWN buttons so
that "DMX Setting" is highlighted, then press ENTER.
2. Press the UP or DOWN buttons until "DMX Address" is displayed,
and press ENTER. The current DMX address will now be displayed.
3. Use the UP or DOWN buttons to adjust the DMX address.
4. Press ENTER to confirm or press MENU button to return to the
main menu.
DMX Channel Mode - With this function, you can select your desired
DMX channel mode.
1. Access the main menu, and press the UP or DOWN buttons so
that "DMX Setting" is highlighted, then press ENTER.
2. Press the UP or DOWN buttons until "DMX Channel Mode" is dis-
played, and press ENTER. The current DMX channel mode will now
be displayed.
3. Press the MENU button to return to the main menu.
This mode can be used as a precaution mode, that
DMX State -
in case the DMX signal is lost, interrupted, or power is lost, the
operating mode chosen in this setup is the running mode the
fixture will go into when the DMX signal is lost. You can also
set this as the running mode you would like the unit to return to
when power is applied.
1. Access the main menu, and press the UP or DOWN buttons so
that "DMX Setting" is highlighted, then press ENTER.
ADJ Products, LLC - www.adj.com - Vizi BSW 300 Instruction Manual Page 24
System Menu Vizi BSW 300
2. Press the UP or DOWN buttons until "DMX State" is displayed,
and press ENTER. Use the UP and DOWN buttons to switch between
the two modes; Blackout or Hold. Press the ENTER button to make
your selection.
• LAST STATE - If the DMX signal is lost the fixture will stay in the
last DMX setting. If power is applied and this mode is set, the unit will
automatically go into the last DMX set up.
• BLACKOUT - If the DMX signal is lost or interrupted, the unit will
automatically go into stand by mode.
• MASTER/SLAVE - If the DMX signal is lost or power is applied, the
unit will automatically go into Master Slave mode and run a built-in
show.
3. Press the MENU button to return to the main menu.
SHOW SETTINGS -
Show Mode - Select a desired preset show to run.
1. Access the main menu, and press the UP or DOWN buttons so
that "Show Setting" is highlighted, then press ENTER.
2. Press the UP or DOWN buttons until "Show Mode" is displayed,
and press ENTER. The current setting will now be displayed.
3. Use the UP or DOWN buttons to find your desired show. Shows
1-4 are factory shows, while Show 0 is a random show.
4. Press ENTER to confirm your selection or press the MENU button
to return to the main menu.
Slave Mode - Use this mode to set the unit as a "Master", "Slave 1"
or "Slave 2"
1. Access the main menu, and press the UP or DOWN buttons so
that "Show Setting" is highlighted, then press ENTER.
2. Press the UP or DOWN buttons until "Slave Mode" is displayed,
and press ENTER. The current setting will now be displayed.
3. Use the UP or DOWN buttons to find your desired setting. Select-
ing "Slave 2" will give the unit contrast movement to the "Master":
ADJ Products, LLC - www.adj.com - Vizi BSW 300 Instruction Manual Page 25
System Menu