Throttle Curve - JR Racing R-1 User Manual

Throttle Curve

The R-1 features an 8 point throttle that allows you to
precisely adjust the throttle and brake response. Two 8 point
curves can be set up, and each can be selected with the
Drive Mode switch (position 0 or position 1).
Indicates forward or brake curve
(press PAGE to select)
Drive mode switch position
Selected programming point:
N = Neutral
1 = 25% forward or brake trigger position
2 = 50% forward or brake trigger position
3 = 75% forward or brake trigger position
H = Full forward trigger position
L = Full brake trigger position
Trigger position
Output position
Press the MODELIST key
to return to Direct Mode
Press the UP key to go to
Throttle Hold
Press the PAGE key to
select forward or brake
curve
Press the CLR key to reset
the selected points to
factory settings
A digital graph shows the position of the servo (or throttle
amount when using a electronic speed controller) at each
throttle position (L, 3, 2, 1, N, 1, 2, 3, H). Note: The factory
presets for the throttle curve is a straight (linear) response
with positions N preset at 50%, 1 inhibited, 2 at 75%, 3
inhibited and H at 100%. To activate inhibited points, select
that point and press the + or - key. The value at position N in
forward and brake curve will always be 50% and can't be
changed.
30
In Function Mode, access the Throttle Curve function by
moving the cursor to THRO CURV and pressing the MODE
LIST key.
Vertical line moves
corresponding to throttle trigger
position
[THRO CURV]
£Forward
Pos-0
∞Point-N
50.0%
°· 50 fifl‡ 50 · ⁄ ¤ ‹ ›
Forward
Each point can be selected and varied. On the forward curve,
it can be adjusted from 50 to 100%, and on the brake curve
from 50 to 0.
Stored output value at above
listed point
Press the + or – keys to
adjust the value at each
selected point
Press the SEL key to select
points N, 1, 2, 3, H, L or
Expo function
Press the DOWN key to go
to Speed Adjust