Speed Adjust - JR Racing R-1 User Manual

Speed Adjust

The R-1 allows you to adjust the steering servo's speed
independently away from center (turning), as well as back to
center (return). Also a point can be selected in both turning
and return, and the speed between each point can be inde-
Selected channel, throttle
or steering
Turns servo speed from neutral
outward
Stored point at which low and high
speed steering values meet
Press the MODELIST key to
return to Direct Mode
Press the UP key to go to
Throttle Curve
Press the PAGE key to choose
the desired channel (steering
or throttle) and to select turn or
return
Press the CLR key to reset
value to factory preset
Note: When the Pnt. value is set at 0, the steering
servo's speed is adjusted using the high value,
and the low value will be ignored. If the Pnt. value
is set at 100, the low value adjusts the servo
speed. If you choose to use only one speed, then
set the Pnt. to 0 and adjust using the high value.
32
pendently selected. Two separate speed adjust values can be
set and selected using the Drive Mode switch (position 0 or
position 1).
In Function Mode, access the Speed Adjust function by
moving the cursor to SPEED ADJ and pressing the MODE
LIST key.
[SPEED ADJ]
ST. POS-0
£Turn Return
∞Pnt. 50 Pnt. 50
Low INH Low INH
Hi INH
Adjustment values can be set from 1 to 125. The smaller the
value, the slower the servo speed.
Remember, two separate speed modes can be programmed
and selected via the Drive Mode switch.
When the Speed Adjust function is turned on, SPEED will
flash on the normal screen.
Drive mode switch position
Returns servo speed from a turn
back to center
Stored low value
Hi INH
Stored high values
Press the + or – keys to select
the desired values
Press the SEL key to select the
point, low or high positions to
be programmed
Press the DOWN key to go
to A.B.S.