Tx Mode - JR Racing R-1 User Manual

Tx Mode

The Tx Mode allows the setting of five different transmitter
parameters—Mode, Buzz Tone, AUX 3 Channel, Warning,
and D. T. Display.
To programmable mix 2
To reverse switch
Mode
Mode allows the selection of either beginner or expert
mode. In beginner mode, several of the more sophisticated
functions, such as throttle hold, speed adjust, quick throttle,
A.B.S. braking, quick throttle, idle up, function select, trim
rate, and programmable mixing, are omitted, making it easi-
er for beginners to program their radio.
In expert mode, all functions appear and are accessible on
the Mode List screens.
Buzz Tone
Selecting buzz tone allows you to vary the pitch of the
buzzer. 20 levels are available, and 0 is the factory default
setting.
Aux.3 Channel
The Aux.3 channel can be programmed to any available (not
assigned to anything else) digital trim or switch. When
In System Mode, access the Tx Mode function by moving
the cursor to TX MODE and pressing the MODE LIST key.
[TX MODE]
∞ Mode: Expert
BUZZ TONE:
AUX=3ch: D.Trim
Warning: ON
D.T. Disp: Off
Aux.3 is inhibited, the third channel's output is fixed at neu-
tral, allowing channel 3 to be used as a slave with program-
mable mixing. This is useful for dual steering servos or dual
throttles.
Warning
The warning switch can be turn on or off. With the warning
switch in the on position, if the transmitter is turned off and
the drive mode or idle up switch have been changed since
the transmitter was last turned off, an alarm will sound and
the screen will display the switch at fault. Turn the switch to
the opposite position to stop the alarm.
D.T. Display
The Digital Trim Display can be turned on or off. In the on
position, a graph is displayed on the info screen, visually
showing the trim positions.
0
Press + or – keys to
change the value or
selection of the selected
feature
Press the SEL key to
move the cursor to the
desired position
25