Strand Mounting The Node - Cisco GS7000 Installation And Operation Manual

Strand Mounting the Node

Description
The following procedure explains how to install the 1.2 GHz GS7000 Node on a
strand (aerial installation). Strand mounting allows street-side access to the housing.
Procedure
Follow this procedure to mount the housing to a strand. The housing does not need
to be opened for strand installation.
WARNING:
Be aware of the size and weight of the node while strand mounting.
Ensure that the strand can safely support the node's maximum weight.
A fully loaded 1.2 GHz GS7000 Node weighs over 50 lbs (22.7 kg).
Ensure the ground area below the installation site is clear of personnel
before hoisting the node. If possible, block off walkway below the
hoisting area to prevent pedestrian traffic during hoisting.
Failure to observe these admonishments can result in serious injury or
death.
1 Check the strand size. The minimum strand diameter should be 5/16 inch.
2 Attach the strand clamp brackets to the housing in the position shown in the
following illustration. Use a torque wrench tightens the strand clamp bracket
bolts from 5 ft-lb to 8 ft-lbs (6.8 to 10.8 Nm).
Strand Mounting the Node
37