Cisco GS7000 Installation And Operation Manual page 24

Chapter 1 General Information
Node Inputs/Outputs Diagram
The following diagram shows the system-level inputs and outputs of the 1.2 GHz
SHO GS7000 Node.
Note: Port 3 and 6 are only for power.

The AC can be applied through any housing base port and routed, if required,
to the other ports.

The DC power supply modules can be fed by any housing base port (1
through 6).
Modules Functional Descriptions
This table briefly describes each module. The 1.2 GHz SHO GS7000 Node may not
contain all these modules. See Theory of Operation (on page 11) for detailed
descriptions of the modules.
Module
RF Amplifier
Optical Receiver
6
Description
The RF Amplifier Module includes:

four forward RF output ports

four reverse inputs.

forward and reverse bandwidths that are established by diplexer
and reverse low pass filter assembly selection.
This module converts an optical signal from the headend into a
forward path RF signal. An SC/APC fiber connector is standard.
Optical power, test points, and status LEDs are provided.